Ender 5 S1 Mercury One
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of ZeroG's Mercury One corexy mod to allow it to fit on an E5S1.
- Rating
- 5 / 5
- Likes
- 55
- Downloads
- 241
- Makes
- 3
- Views
- 3,107
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
What is this for? :
Here is a remix of the Mercury one Electronics enclosure and CoreXY mod so it can fit an E5S1 (Ender 5 S1). The normal Ender 5 (pro) is wider than the E5S1, so the original skirts didnt fit on the front and in the back of the printer. Now it does! Also, there are a few parts that were not fitting on the E5S1 so I had to remix them.
I also added the following changes to make your (and my) life easier:
-I changed the holes in the skirt so now you need M3 bolts instead of M5 bolts.
-I added 3d printable bottom panels to avoid buying custom CNC panels. I printed them in ABS, (wich I would not recommend due to shrinkage. I had to force a bit to make the panels fit)
-I designed a simple limit to the Y axis rail to avoit it unrailling by mistake.
-A adapted the Eva 2.4 toolhead to make it fit a MGN9H carriage and rail with an orbiter extruder.
My setup :
-MainBoard : Btt octopus v1.1
-MCU: BTT Pi2
-Stepper Drivers : TMC2240
-StepperMotors : LDO-42STH48-2504AH
-Bed : Stock bed that came with the printer
Toolhead:
-Toolhead board : Mellow Sht36 V3 (Canbus) (with 31865 chip)
-Extruder : LDO Orbiter V2
-Hotend : Phaetus Rapido 2 HF
Instructions:
I followed ZeroG's MercuryOne Build guide for pretty much everything with some minor changes :
-Put the y endstop inside of the frame (as in the picture below) since the outside doesnt have a slot.
-Reverse the bed's nut so that the lead screw isnt too short.
