1 / 7
Silly Shell -- 9x Short Darts -- Airtight Barrels 3x3 Short Darts -- Triple Ramrod — image 1
1 / 7

Silly Shell -- 9x Short Darts -- Airtight Barrels 3x3 Short Darts -- Triple Ramrod

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

3x separate airtight barrels --- triple ramrod --- no loss of air pressure --- better dart fit

Rating
5 / 5
Likes
31
Downloads
87
Makes
4
Views
556
Reviews
4

Updated at source:

Model information

Category
Outdoor Toys
License
Creative Commons — Attribution — Noncommercial — Share Alike

Updated Version 1.1

9x Short Darts ----- Silly Shell ----- with 3x airtight  barrels
 
9x Short Darts  (3x3) 
or 27x caliber .50 Foam Balls

+ Loading Tool with 3 ramrods for fast and easy loading.


I added 3 separate airtight  barrels to a silly shell for better dart fit 
and no air pressure loss when shooting.

This shell brings an FPS boost and an increase in accuracy and range.

Alternatively, you can use this Silly Shell to shoot .50 caliber FOAM balls. 9 of these can be loaded into each barrel, so a total of 27 FOAM balls.

This shell has a length of 125,8mm and is longer than the normal Silly Shells and therefore more suitable for blasters like the Anemone, Wildstyle or Silly Shell Launcher Attachments. 


FPS test with the Anemone (3 bungee loops):
  
9x Short Darts:      ~ 79 FPS

I've also designed a few other unconventional multi-dart silly shells with separate airtight barrels or spigots:
*   6x / 9x / 12x Short Dart Silly Shell (+Triple Ramrod)
*   4x / 5x MEGA Dart Spigot Silly Shell
*   SNIPER + MEGA XL Spigot Silly Shell

  • Update 12.5.2025:
    Made the barrels slightly wider in the lower third to reduce friction and make loading the last dart a little easier. Additionally, a dart stop was added to the end of the barrels.

  • Update 14.5.2025:
    Added a tool with 3 integrated ramrods to load the barrels easily and fast.

The file is already pre-oriented.

Print settings (the same settings as for the other Silly Shells):
0,2mm layer height
at least 5 walls
20% gyroid infill
at least 7 top and bottom shell layers
wall generator: Arachne

Print with brim if you have poor print bed adhesion.
NO supports needed.

Sillybutts recommends 100% infill for the first 13mm of the Silly Shells. 

As with all printed barrels, it is always a very good idea to sand the inside of the barrels to smooth it out a bit. Sanding also makes loading the barrels easier.

Thanks to Sillybutts for the files that I could use for this remix.

Tags