T-Pull * Iron Sights * Rail Cover * Spring Spacer --> Blitzfire 2 * Dart Zone (Nitroshot)

Dart Zone Nitroshot Blitzfire2 Mods
 

• T-Pull + Printed Pin 

• Rear Sight Insert for improved aiming

• Bottom Rail Cover for some additional color accent

• Spring Spacer (for the stock spring)
   
  All mods can be easily reversed if desired.
  

Installation:

Simply open the 3 screws on the slide, place the Rear Sight Insert into the recesses of the stock rear sight and screw the slide back together.

The T-Pull simply attachs with the printed pin through the faux hammer. The pin may be a little difficult to insert because it fits quite tightly to press the T-pull onto the top slide so that it doesn't wobble later.

Some 2mm crafting foam (or similar) to secure the Bottom Rail Cover to the rail.
(put a strip of crafting foam between the rail and the Bottom Rail Cover to secure it like shown in the photos. A section of a halfed foam dart also works well for this.)

--------------------------------------------------------------------------

The optional small spring spacer gives some extra FPS (approx. +5fps).
Install it like shown in the picture.

• UPDATE 16.12.2025:
  Shortened the T-Pull by 5mm in length for optical reasons.
  Added a Drop In Rear Sight Insert for improved aiming.

--------------------------------------------------------------------------------------------------------------

The files are already pre-oriented:

My print settings for PLA:
0,2mm layer height
4-5 walls
7 top and bottom shell layers
20% gyroid infill
(print with outer brim if you have poor bed adhesion)

Thanks to Onino for the files I could use for this remix.