Creality 20x20 Extrusion LED Bar Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clip-on mount for a Silvercrest LED bar on Creality printers with 20x20 extrusion rails (CR6-SE, Ender).
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Compatibility
Any printer frame with a 20x20mm extrusion rail (CR6-SE, Ender 3/3 Pro/3 V2/3 S1, etc.)
Silvercrest LED bar, cross-section 40x9mm (the slim aluminum housing model with a rounded profile)
Printing notes
No supports needed
2 clips required per LED bar (one at each end)
Standard PLA or PETG works fine, this part isn't near any heat source
Assembly
Slide the clip onto the extrusion rail, then snap the LED bar into the hook feature on the underside of the clip. The design uses a slight interference fit, so no screws or glue are needed — just a firm push to seat it.
Notes
If your LED bar has a different housing profile, check the hook dimensions in the model before printing (40x9mm cross-section), this was measured directly off a Silvercrest unit.