UPDATE! - Simple Speedloader v2 - X-Shot Spinshot / Break Barrel Blaster

🟪 UPDATE 3.8.2026:
A new version has been added, featuring a top and a movable bottom plate. So two parts need to be printed here.
The bottom plate is guided along an axis and pushes the darts completely out of the speedloader into the chambers.
For this version, you’ll need a suitable O-ring of some sort to fit at the bottom of the axle to prevent the bottom plate from slipping down off the axle.
(O-rings with an internal diameter of between 11 mm and 16 mm will work. Cord thickness 1,5 to 2 mm. Old, worn O-rings can also be used)

🟪 UPDATE 9.8.2026:
I have slightly enlarged the hexagonal hole in the bottom plate by 0.2 mm because  depending on the printer setup or filament, it could become too tight.

Simple Speedloader
X-Shot Spinshot / Break Barrel

Version 1 requires just 7 g of filament.
The improved version 2 requires approx. 17 g of filament.
Both are quick and easy to print.

🟧🟪 There are two versions available :

🟧 Version 1:
Here, the darts are simply pushed out of the speedloader and into the chambers using your fingers.

🟪 Version 2 (improved):
It also features a movable bottom plate that allows the darts to be pushed all the way from the speedloader into the chambers. 
For this version, you’ll need a suitable O-ring of some sort to fit at the bottom of the axle to prevent the bottom plate from slipping down off the axle.
>>> O-rings with an internal diameter of between 11 mm and 16 mm will work. Cord thickness 1,5 to 2 mm. Old, worn O-rings can also be used! <<<

>>> Both versions have a mounting bracket that can be attached to JC Works’ Cylinder Mount for MOLLE / Belt <<<

--------------------------------------------------------------------------------------------------------------------------

The file is already pre-oriented.

My print settings for PLA:
0,2mm layer height
2-3 walls
7 top and bottom shell layers
10% gyroid infill

NO supports needed

Thanks to JC works for the files I could use for this remix.