Printed Barrel with Integrated Adapter - Hardware Free - X-Shot Spinshot / Break Barrel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printed 170mm or 120mm barrel with integrated adapter in one piece. No aluminium barrel needed. Works with stock muzzle.
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 127
- Wydruki
- 3
- Wyświetlenia
- 688
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Full-Printed Barrel with Integrated Adapter 🟪🟧 170 mm or 120 mm length
X-Shot Spinshot / Break Barrel
🟦 no additional hardware required
🟦 prints in one piece (without supports)
🟦 barrel inner diameter: 13 mm or 12.9 mm
🟦 barrel length: 170 mm or 120 mm
🟦 works with the stock muzzle
🟦 SCAR, BCAR etc. can be attached to the 170mm barrel
The front section of the 170mm barrel has an outer diameter of 16 mm (just like an aluminium barrel), so that BCARs or SCARs can be attached.
This section is 50 mm long and offers plenty of space, even for a Silly SCAR.
(The wall thickness in this area is 1.5 mm, which is approximately 4 walls)The shorter 120mm barrel protrudes only slightly beyond the stock muzzle at the front - if you’d prefer a shorter version.
Performance boost with the stock spring and cylinder:
🟪 170 mm barrel approx. + 40 FPS
🟧 120 mm barrel approx. + 30 FPS
🟪 The long 170 mm barrels also dampen the blaster’s noise level by quite a bit.
By fitting a Silly SCAR (e.g. the silencer-style one shown in the photos), you can reduce the noise level even further.
🛠 For installation, please have a look at TaG’s modding video;
the procedure is basically the same, except that my full-printed barrels are compatible with the blasters stock muzzle and do not require an additional aluminium barrel.
-----------------------------------------------------------------------------------------------------------------------
Update 11.9.2026:
Just a small, optional and purely cosmetic addition.
I added thin spacer sleeves (16mm to 17mm outer diameter) to bridge the gap between the barrel and your attachments. They also work great for adding a nice color accent! Simply slide the sleeve onto the barrel before installing your muzzle device. (as can be seen in one of the photos)🟪 There are two versions: one for the Silly SCAR and one for the EX BCAR 2.
-----------------------------------------------------------------------------------------------------------------------
One barrel requires only approx. 15–19g of filament.
The files are already pre-oriented.
🟦 My print settings for PLA:
0,2mm layer height
5 walls
20% gyroid or cubic infill
7 top and bottom shell layers
Wall Generator: Arachne
NO supports needed
Use an outer brim if you have poor print bed adhesion !‼