FLSUN QQS-Pro Sherpa Mini + Volcano Direct Drive – Heat-Set Inserts & Sliding 5015 Ducts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One-piece Sherpa Mini direct drive for the QQS-Pro, with a Volcano hotend, heat-set inserts, dual 5015 sliding ducts and
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Remixed in blender using Claude Opus 5.5 and blender MCP.
A direct-drive conversion for the FLSUN QQS-Pro: a Sherpa Mini extruder above the effector, an E3D Volcano below it, twin 5015 part-cooling fans, and the stock clip-on levelling probe still working.
This is a remix of SpaceSputnik's one-piece Sherpa Mini mount (Thingiverse 4932620), which is itself a remix of Chrztal's original (Thingiverse 4830145). Credit to both. The hotend clamp is Chrztal's, unchanged.
Printed parts
Housing / effector (1×). Print plate-down with supports. Mine used 7 walls, 7 top/bottom layers and 25% gyroid, about 63 g. PETG at minimum, never PLA. It sits right next to the hotend. The original author recommends CF-PETG.
Hotend clamp (1×)
Fan connector A + B. Each one has a functional face on both sides, so whichever way you lay it, one face gets support marks. Put them on the side that matters least to you.
Fan duct A + B. Stand them on the outboard end of the header.
Cable tie post. Print flange-down. The tie slot bridges without support.
Optional: collar test coupons. 5015 fans vary. Mine have a 16.4 × 12.6 mm outlet and the 16.3 × 12.6 collar fit best. Print the coupons first if your fans are different.
Hardware
Sherpa Mini extruder (Trianglelab / Annex) and its stepper
E3D Volcano (I used the sensor-cartridge block)
2× 5015 blower fan, 1× 40×20 hotend fan
16× M3 heat-set inserts, 4.4 OD × 3.9 long. The four hotend-fan holes are only 4.5 mm deep, so use inserts 4 mm long or shorter there.
6× M3 for the arms, 2× M3 for the Sherpa
2× M3×18 socket head (probe plate → duct connector → housing)
2× M3×20 (blower lower ears)
4× short M3 (hotend fan)
1× M3×25 + hex nut (hotend clamp, through the cable tie post; M3×22 also works)
Cleanup: Worth noting that I used tree supports and did a fair bit of sanding to get a reasonably smooth matt finish.
Assembly order: connector onto the fan → fan + connector onto the housing → M3 up through the probe plate, connector and housing → slide the duct on from the outside.
After fitting: the new toolhead changes your max height, Z offset, rotation distance, pressure advance and retraction. Re-home, run delta calibration and redo all of them. I run Klipper.
