1 / 3
Ender 3 Pro Mini Satsana Remix - 4020 Blower Fan - Micro Swiss Direct Drive — image 1
1 / 3

Ender 3 Pro Mini Satsana Remix - 4020 Blower Fan - Micro Swiss Direct Drive

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of the popular mini Satsana Ender 3 Pro fan duct to use a 4020 blower fan.

Rating
5 / 5
Likes
20
Downloads
170
Makes
1
Views
1,869
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

04-29-2023 UPDATE: After putting my printer in an enclosure, I noticed the cooling I was able to achieve took a hit, possibly due to the old design pulling in air directly from the print bed. This update moved the fan back to the side of the fan duct and also moved the CR-Touch to the left side.

01-18-2023 UPDATE: Added more clearance for a screwdriver for hex key and a mount for CR-touch probes.

07-28-2022 UPDATE: I added a small notch on the left side to ease access to the top mounting screw. Also, I added a boss to the retainer clip so spacer washers are no longer needed.

I wanted to use 4020 blower fans with the mini Satsana so I added support arms to accommodate the fan mounting. By positioning the fan in the front-center it allows for a more even flow pattern than the original (blower on the right side). I have been using it for a few weeks now and have seen a noticeable improvement in print quality (overhangs, bridging, etc.).

#4-40 hardware was used to hold the blower fan on (only had 1-½" length but shorter would look better). Held using stock hardware to X-carriage.

Compatible with stock CR-Touch mounting plate.

I modified the clip on the back to fit the MicroSwiss direct drive better.

I printed in PETG with 0.2mm layer height. No supports are needed if printed with the arms “up” and flat on the build plate.

Tags