Simhub - Drum (No flens) - DIY Belt tensioner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
No more flens needed. easier to install and less harware. Also less play between the drum and the motor
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 125
- Makes
- 0
- Views
- 602
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
!!! During calibration, make sure they do not overtighten or crash into the rig !!!+
To make this drum work properly, the sensor position needs to be adjusted. In my case, I had to move the sensor slightly to get consistent triggering.
There is a left and a right drum.
If it hits the rig wile after calibration is your parked settting make sure to set it higher so it does not hit the rig.
I printed the drum in PLA, using 45% infill and 6 walls.
Hardware Orginal model
8x Heat inserts M3 (5x4L)
8x Bolt M3 (Min 8 Max 14)
Hardware Remix
1× M6 bolt (18 mm+)
1× M6 nut
🔄 Update
Multiple belt sizes have been added.
The model now supports the following belt widths:
55 mm
65 mm
75 mm
79mm
100 mm
This makes the drum compatible with a wider range of DIY belt tensioner setups.
Important disclaimer:
Always test the drums before mounting them on your rig. During calibration, make sure they do not overtighten or crash into the rig.
Huge thanks to Sebastian for creating this awesome model!
Original model:
https://www.printables.com/model/1407951-belt-tensioner-gurtstraffer