CMF Phone 2 Pro sunshade for flying drones

This shade makes shadow on your phone screen, so you can see better when flying drone. It can be attached to CMF Phone 2 Pro using screws so there is no way it will get deattached.

The bump on the top allows for mounting the whole setup to a phone mount on a remote controller. There is also a hole to connect the phone to the remote or to the charger.

Prints very easly from PLA. Uses small supports that are easy to remove.

I don't have CMP Pro2 phone, so the dimensions might be not fine-tuned! You may consider printing just 10 first mm to check if the part fits your phone. If you do that, please let us know, so other users don't need to do the same :)

The pictures show version v1 while the files and renders the current version v2.

printing:

material - PLA (but you may consider more heat-resistant materials)

layer height - around 0.25mm

brim - not required

supports - on

using:

remove “mouse ears” and supports from the print

detach cover from your phone if there is any

slide the phone into the rail on the right side of the cover

screw the cover to the phone

mount the phone to the remote (optional)

credits:

The idea for the project comes from my uncle. I also made the mouse ears basing on the idea of @Ty10y. I looked at the model of @ZR_275888 to make sure I didn't omit any details and following it I added hole for the cable and cavity for the buttons.