EX BCAR Rev2 Thread - Printed Barrel - SIGNET v3 Blaster - Nerf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable barrel with integrated thread for the EX BCAR Rev2 and optional thread protector muzzle for SIGNET v3.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 12
- Wydruki
- 1
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
🟪 100 mm Barrel with EX BCAR Rev2 Thread:
100 mm barrel with integrated thread for the EX BCAR Rev2 and centering ring. It protrudes ~7 mm in front of the handguard.
🔸100 mm barrel segment with 13 mm inner diameter.
🔸+35 mm faux barrel segment with 13.6 mm inner diameter and thread for the EX BCAR Rev2.
An optional thread protector is also included, which doubles as a neat muzzle when no BCAR is attached.
💡 FPS Recommendation: I recommend using a BCAR only for setups hitting 120 FPS or higher, as lower power setups will lose velocity without gaining noticeable stability benefits.
The 7 dot 12 Classic EX BCAR Rev2 would be a good match for the SIGNET v3’s performance range.
Lightly sand the inside of the printed barrel with a rolled-up piece of sandpaper.
------------------------------------------------------------------------------------------------------------------------------
The files are already pre-oriented.
My print settings for PLA:
0.2 mm layer height
5 walls
20% gyroid or cubic infill
7 top and bottom shell layers
Wall Generator: Arachne
Scarf Seams
Supports needed!
Use an outer brim if you have poor print bed adhesion!
🧩 Check out my SIGNET v3 Collection:
Find all my matching mods for the SIGNET v3 in one place.
Thanks to Acorn Armaments and Epicxxxx for the files I could use for this Remix.