EX BCAR Rev2 Thread - Printed Barrel - SIGNET v3 Blaster - Nerf
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printable barrel with integrated thread for the EX BCAR Rev2 and optional thread protector muzzle for SIGNET v3.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 12
- Makes
- 1
- Views
- 180
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
🟪 100 mm Barrel with EX BCAR Rev2 Thread:
100 mm barrel with integrated thread for the EX BCAR Rev2 and centering ring. It protrudes ~7 mm in front of the handguard.
🔸100 mm barrel segment with 13 mm inner diameter.
🔸+35 mm faux barrel segment with 13.6 mm inner diameter and thread for the EX BCAR Rev2.
An optional thread protector is also included, which doubles as a neat muzzle when no BCAR is attached.
💡 FPS Recommendation: I recommend using a BCAR only for setups hitting 120 FPS or higher, as lower power setups will lose velocity without gaining noticeable stability benefits.
The 7 dot 12 Classic EX BCAR Rev2 would be a good match for the SIGNET v3’s performance range.
Lightly sand the inside of the printed barrel with a rolled-up piece of sandpaper.
------------------------------------------------------------------------------------------------------------------------------
The files are already pre-oriented.
My print settings for PLA:
0.2 mm layer height
5 walls
20% gyroid or cubic infill
7 top and bottom shell layers
Wall Generator: Arachne
Scarf Seams
Supports needed!
Use an outer brim if you have poor print bed adhesion!
🧩 Check out my SIGNET v3 Collection:
Find all my matching mods for the SIGNET v3 in one place.
Thanks to Acorn Armaments and Epicxxxx for the files I could use for this Remix.