1 / 18
Prusa XL Belt Tension Alignment Calibration Spacer Tool — image 1
1 / 18

Prusa XL Belt Tension Alignment Calibration Spacer Tool

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a small but powerful tool that helps you adjust the belt tension and alignment on your Prusa XL perfect evenly.

Rating
5 / 5
Likes
47
Downloads
461
Makes
6
Views
2,008
Reviews
6

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Hello XL printers,

I was one of the first to receive a Prusa XL Multitool printer. From the start, I had problems tightening the belt equally on both sides and still aligned parallel so that there is no gap on either side.

Since I've spent a lot of time researching the problem, I know many people have this problem. So I tried a lot of things and have finally found a working solution!

Here you find the full guide: 

https://investegate.de/prusa-xl-belt-tension-alignment-calibration-guide

Quick Guide Overview:

  • After each adjustment, the entire carriage must be rotated 1-2 times completely back and forth and completely left to right and back to the belt to evenly distribute the tension across the entire belt. Only then measure again. (Video)
  • The adjustment position is always in the very center of the front.
  • The measurement position is as shown in the Prusa Video.
  • The alignment check position is in the front left and right.
  • If there is a gap on the left, the spacer should be right.
  • If there is a gap on the right, the spacer should be left.
  • Always alternate between a maximum of 0.5 to 1 turns per side and a maximum of 2 full turns per adjustment procedure.

 

Tags